Electronics Line 3208GLD Manual do Utilizador descarregar pdf (Página 18)

Note: In the message to the central station, the control panel always indicates the system of the keypad

from which the duress code was entered.

User codes and system partitioning

When the Summit 3208GLD is partitioned into several sub-systems, user codes can be associated either with a

specific sub-system or with the entire system. Assigning a user code to only one system will default all

operations to that system. For example, if a user code is assigned to system 3, entering the code arms system

3 without the need to indicate the system number. A user code authorized to all of the subsystems can perform

functions affecting the entire system, such as arming and disarming. To assign a user code to all of the

systems, program the code as belonging to system 5.

Programming User Codes

To program user codes (LCD keypad only):

1. Select User Codes from main menu or press SELECT, 5; the LCD display requests a user code.

2. Enter an authorized user code; the display reads:

In the above example: The code displayed is for User 1. The user code is “1234” - 4 digits with “..” following,

signifying that two digits were not used in this user code. The user code is assigned to system 1. The user code

authorization level is 10. The current field is indicated by “>”.

3. To scroll through the user codes, press MENU/NEXT to scroll forward and Q to scroll back.

4. To scroll through the different fields, press SELECT.

5. To change the value of the current field, enter the required value.

6. Press AWAY to exit user code programming or MENU/NEXT to program the next user code.

Note: A user cannot program a code to a higher access level or to a sub-system other than the one to

which their code belongs. Additionally, a user cannot view user codes assigned to a higher access

level. The system accepts the first user code it recognizes. To prevent being locked out of the system,

do not program user codes beginning with the same numeric combination. For example, the 3 digit

user code “123” and the 4 digit code “1234” are programmed in the same system. Any attempt to enter

“1234” is impossible as the system recognizes “123” the moment the third digit is entered.

3.8: Zone Bypassing/Unbypassing

A bypassed zone is ignored by the system when arming. Bypassing and unbypassing can only be performed if

the system is disarmed.

To bypass a zone:

1. From the Bypass menu, select Bypass or press SELECT 3, 1.

2. Enter an authorized user code and a zone number.

To unbypass a zone:

1. From the Bypass menu, select Unbypass or press SELECT 3, 2.

2. Enter an authorized user code and the bypassed zone number.

To unbypass all zones:

1. From the Bypass menu, select Unbypass All or press SELECT 3, 9.

2. Enter an authorized user code.

Note: On a control panel with zone expanders, the control panel waits for an extra digit when zones 1,

2 or 3 are bypassed. This allows bypassing of the additional zones (for example, 11, 24, or 32). In this

case, when enter the zone number and press MENU/NEXT to indicate that no additional digit is

necessary.

USER 01 : > 1234. .

SYS. : 1 LEVEL: 10

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 50 51

Comentários a estes Manuais

Sem comentários

Electronics Line 3208GLD Manual do Utilizador Página 18

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Electronics Line 3208GLD